Part Number Hot Search : 
2SD1770 TF1204 TSP350BL LA6542M 1N4735 F1200D 74AUP1 KDZ15FV
Product Description
Full Text Search
 

To Download NSD15-12D12 Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 15W DC-DC Regulated Single Output
Features :
Wide 4:1 DC input range
NSD15-S
Protections: Short circuit / Overload / Over voltage 1500VDC I/O isolation Built-in EMI filter Cooling by free air convection Output voltage trimming function Built-in remote ON-OFF control 100% full load burn-in test Lost cost High reliability 2 years warranty
series
SPECIFICATION
MODEL DC VOLTAGE RATED CURRENT CURRENT RANGE RATED POWER OUTPUT CAPACITIVE LOAD (max.) VOLTAGE TOLERANCE Note.3 LINE REGULATION LOAD REGULATION TRIM OUTPUT (Typ.) RATED DC INPUT VOLTAGE RANGE EFFICIENCY (Typ.) DC CURRENT SHUTDOWN IDLE CURRENT OVERLOAD NSD15-12S3 3.3V 3.75A 0.18 ~ 3.75A 12.37W 3300uF 75mVp-p(25% ~ 100% load) 2.0% 1.0% at 10% ~ 100% load 1.0% at 10% ~ 100% load +10% 12VDC 9.4 ~ 36VDC 73% 1.8A/12VDC 20mA 5.0% 5.0% 3.0% +10% 48VDC 18 ~ 72VDC 77% 0.4A/48VDC 5.0% 5.0% 3.0% NSD15-12S5 5V 3A 0.15 ~ 3A 15W NSD15-12S12 12V 1.25A 0.06 ~ 1.25A 15W NSD15-12S15 15V 1A 0.05 ~ 1A 15W NSD15-48S3 3.3V 3.75A 0.18 ~ 3.75A 12.37W NSD15-48S5 5V 3A 0.15 ~ 3A 15W NSD15-48S12 12V 1.25A 0.06 ~ 1.25A 15W NSD15-48S15 15V 1A 0.05 ~ 1A 15W
RIPPLE & NOISE (max.) Note.2 100mVp-p(25% ~ 100% load) for 3.3V only
INPUT
77%
81%
81%
81%
84%
85%
Above 105% rated output power Protection type : Over power limiting, recovers automatically after fault condition is removed PROTECTION 5.8 ~ 6.93V 5.8 ~ 7.5V 13.8 ~ 18V 17.25 ~ 22.5V 5.61 ~ 6.93V 5.5 ~ 7.5V OVER VOLTAGE(CLAMP) SHORT CIRCUIT Note.4 Recovers automatically after fault condition is removed Logic "1" or open circuit : ON Logic "0" or short to PIN2 : OFF FUNCTION ON/OFF CONTROL -25 ~ +70 WORKING TEMP. ENVIRONMENT WORKING HUMIDITY STORAGE TEMP., HUMIDITY 0% ~ 95% RH max. -40 ~ +85 , 0 ~ 95% RH 0.03%/ (0~50 UL60950-1 approved, Design refer to TUV EN60950-1 I/P-O/P:1.5KVDC I/P-O/P:100M Ohms/500VDC 25 70%RH Compliance to EN55022 (CISPR22) Class B Compliance to EN61000-4-2,3,4,6,8; EN55024, light industry level, criteria A 1734K hrs min. MIL-HDBK-217F (25 ) 50.8*38.1*9.82mm (2"*1"*0.387") (L*W*H) 0.03Kg; 180pcs/6.4Kg/0.97CUFT
13.8 ~ 18V
17.25 ~ 22.5V
TEMP. COEFFICIENT SAFETY STANDARDS SAFETY & ISOLATION VOLTAGE ISOLATION RESISTANCE EMC (Note 5) EMI CONDUCTION & RADIATION EMS IMMUNITY MTBF OTHERS
NOTE
DIMENSION PACKING
1. All parameters NOT specially mentioned are measured at 12, 48VDC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Short circuit no more than 60 seconds. 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. 6. Derating to 80% load is needed for NSD15-48S series at 18Vdc input voltage. Full output wattage can be acquired when the input voltage is higher than 20Vdc. 7. EMC filter suggestion:
80uH + Vin 680uF + PSU + Vo -
File Name:NSD15-S-SPEC 2007-09-21
15W DC-DC Regulated Single Output
Mechanical Specification
50.8[2]
NSD15-S
5.84[0.23]
series
Unit:mm[inch]
13.33[0.525]
1.8[0.071] 1[0.039]
5.08[0.2]
6 1 +VIN 2 -VIN -VOUT 4 CONTROL TRIM 8 7
6.35[0.25]
50.8 [2]
Pin No. Assignment
Pin No. 1 2 3,5 4 Assignment +VIN -VIN No Pin CONTROL Pin No. 6 7 8 Assignment +VOUT -VOUT TRIM
Block Diagram
EMI FILTER POWER SWITCHING RECTIFIERS & FILTER
3.81[0.15]
45.72 [1.8]
10.16[0.4] 10.16[0.4]
+VOUT
38.1[1.5]
10.16[0.4]
9.82[0.387]
fosc : 400KHz
+VOUT -VOUT
I/P
O.L.P. C TRL
PWM CONTROL
DETECTION CIRCUIT
TRIM
O.V.P.
Derating Curve
ON/OFF Control & Output Trim
1 +VIN +VOUT 6 LOAD 2 7 -VIN -VOUT 0 ~ 100K 4 C TRL TRIM 8 UP DOWN TRIMPOT 0 ~ 100K
100
80 75 60
LOAD (%)
40
CONTROL INPUT.....................................PIN4
20
CONTROL COMMON................................PIN2 LOGIC COMPATIBILITY......CMOS OR OPEN COLLECTOR TTL
-25
0
10
20
30
40
50
60
70 (HORIZONTAL)
CONTROL VOLTAGE ON............+5.5VDC min OR OPEN CIRCUIT OFF......+2.5VDC max. OR SHORT TO PIN2
AMBIENT TEMPERATURE ( )
File Name:NSD15-S-SPEC 2007-09-21


▲Up To Search▲   

 
Price & Availability of NSD15-12D12

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X